XRoar - WD2797
Posted: Thu Apr 11, 2024 6:45 pm
@Ciaran
Hello,
I was trying to read a track at once using the command apparently supported by the controller inside the Dragon (WD2797)
but I cannot get it to work.
Is this command ($E0) supported on XRoar or should I try it on real hardware?
Thanks in advance
pere
Ps Tracing the program with GDB I found that an NMI is received at the same time I send the command to $FF40
that seems strange to me ... it should be generated when the command is completed!
Hello,
I was trying to read a track at once using the command apparently supported by the controller inside the Dragon (WD2797)
but I cannot get it to work.
Is this command ($E0) supported on XRoar or should I try it on real hardware?
Thanks in advance
pere
Ps Tracing the program with GDB I found that an NMI is received at the same time I send the command to $FF40
that seems strange to me ... it should be generated when the command is completed!