Page 2 of 2
Re: CoCoVGA upgrade
Posted: Fri Nov 15, 2019 10:56 pm
by pser1
unumlapis wrote: ↑Mon Nov 04, 2019 9:31 pm
Moving forward slowly and finally got the time this evening to mount the CoCoVGA button board on system. I didn't want to have the port on the dragon case top so aligned the drilling template against the top lower edge and against the power supply port which worked out fine.
Hello,
Is there any chance you could share here that CoCo-VGA drilling template?
I would like to put it inside the box and close it again
thanks in advance
pere
Re: CoCoVGA upgrade
Posted: Tue Nov 26, 2019 7:24 pm
by unumlapis
The drilling template was something that came along together with the CoCoVGA. But, I do believe that there is paper template available [Yepp, found it
here] at the CoCoVGa site. But, if not, I'm happy to take a proper photo of it aligned with a ruler so that you would be able to print it.
Re: CoCoVGA upgrade
Posted: Wed Nov 27, 2019 10:30 am
by pser1
unumlapis wrote: ↑Tue Nov 26, 2019 7:24 pm
The drilling template was something that came along together with the CoCoVGA. But, I do believe that there is paper template available [Yepp, found it
here] at the CoCoVGa site. But, if not, I'm happy to take a proper photo of it aligned with a ruler so that you would be able to print it.
thanks! I found it and have already printed it scale 1:1 verified!
cheers
pere