Hello,
at first I must mention I am just a beginner in 8-bit repairs. I collected few experiences in repairs like changing the capacitors, voltage regulators and building kits like Minstrel 2,3, etc.
I want to play with my Dragon 32 after couple of months again. It was working previously, but now it developed some fatal failure.
I had to power it on and off couple of time to boot in into working state, but after few other tries it died completely. Now I can see only white and black vertical bars on screen.
The processor seems to be live - with scope I see some activity on address and data lines. Couple of time during the probing and restarting the pattern on screen changes, but most of the time I see the vertical bars.
I already removed all the socketed chips and cleaned them with contact cleaner. I am able to remove only memory chips from the daughter board. With removed memory chips the behavior did not changed.
Does anybody has a clue what could the culprit? Where should I start?
M.
Dead Dragon repair - black and white vert.bars on screen
Dead Dragon repair - black and white vert.bars on screen
- Attachments
-
- 20240420_115200 (Large) (Medium).jpg (243.07 KiB) Viewed 1070 times
-
- 20240420_115132 (Large) (Medium).jpg (216.15 KiB) Viewed 1070 times
-
- 20240420_115013 (Large) (Medium).jpg (343.04 KiB) Viewed 1070 times
-
- 20240420_115003 (Large).jpg (655.51 KiB) Viewed 1070 times
Re: Dead Dragon repair - black and white vert.bars on screen
Welcome to the Dragon Archive!
I had a similar problem with a CoCo2, and turn out to be a bad MC6847 video chip.
Other culprits could be the roms. If they have given up their ghost and become corrupted, you could get a bad video initialization.
If you type CLOAD and press Enter, do you hear the relay click?
Do you have any spares, and can we get a picture of your board?
Cheers,
Rob
I had a similar problem with a CoCo2, and turn out to be a bad MC6847 video chip.
Other culprits could be the roms. If they have given up their ghost and become corrupted, you could get a bad video initialization.
If you type CLOAD and press Enter, do you hear the relay click?
Do you have any spares, and can we get a picture of your board?
Cheers,
Rob